VPP CLI
The VPP CLI interface commands:
The VPP cli has several CLI commands to verify configuration:
- to show all configured interfaces:
show interface
- to show interface IP addresses:
show interface address
- show connected PCI interfaces:
show PCI
- various information about the state:
show hardware
- show VxLan tunnel details:
show vxlan tunnel
- show IPSec tunnel details:
show ipsec
- show bond interface config:
show bond
orshow bond details
The VPP CLI bridge domain commands:
The VPP cli has following CLI commands to verify configuration:
- show list of all configured bridge domains:
show bridge-domain
- show details (interfaces, ARP entries, …) for any bridge domain:
show bridge-domain <index> details
The VPP CLI FIB commands:
The VPP cli has following CLI command to verify FIB configuration:
- show list of all configured FIB entries:
show l2fib
The VPP CLI cross-connect commands:
The cross-connect mode can be shown on the VPP with command show mode
The VPP CLI ARP commands:
The VPP cli has following CLI commands to verify configuration:
- show list of all configured ARPs: show ip arp
The VPP CLI Proxy ARP commands:
To verify ARP configuration, use the same call as for the ordinary ARP:
- show list of all configured proxy ARPs:
show ip arp
The VPP CLI route commands:
The route configuration can be verified with:
- show all rotes:
show ip fib
- show routes from the given VRF table:
show ip fib table <table-ID>
The VPP CLI IP scan neighbor commands:
The IP scan neighbor configuration can be verified with:
- show IP scan neighbor:
show ip scan-neighbor
The VPP CLI access list commands:
The VPP does not support any CLI commands related to access list.
In order to retrieve ACL configuration, use vat#
console and direct binary API call acl_dump
.
The VPP CLI IPSec SPD commands:
The VPP cli has a command to show the SPD IPSec configuration: sh ipsec
The VPP CLI IPSec SA commands:
Show the IPSec configuration with the VPP cli command: sh ipsec
The VPP CLI NAT44 global commands:
The VPP cli has following CLI commands to verify configuration:
- show list of all NAT44 addresses:
show nat44 addresses
- show list of all NAT44 interfaces:
show nat44 interfaces
- show list of all NAT44 interface addresses:
show nat44 interface address
The VPP CLI DNAT44 commands:
The VPP cli has following CLI commands to verify configuration:
- show static mappings:
show nat44 static mappings
The VPP cli command (for configuration verification) is show ip punt redirect
.